How do I reset my rev control hub?
Factory Reset Procedure While pressing the button, power on the Control Hub. 3. Release button when Control Hub LED flashes PINK. When Control Hub flashes BLUE then GREEN it has completed the reset and is ready to connect.
How do I connect to my FTC control hub?
Power on the Control Hub, by plugging the 12V Slim Battery (REV-31-1302) into the XT30 connector labeled “BATTERY” on the Control Hub. The Control Hub is ready to connect with a PC when the LED turns green. Note: the light blinks blue every ~5 seconds to indicate that the Control Hub is healthy.
How do I update my FTC control hub?
Select the Control Hub. After selecting the Connected Hardware the Update tab will pop up. Under Hub Firmware select Download. Once the firmware has downloaded, select Update.
What is an expansion hub?
The REV Robotics Expansion Hub (REV-31-1153) is a low-cost education device that can communicate with any computer (Commonly the REV Robotics Control Hub or an Android Phone) to provide the interfaces required for building robots and other mechatronics.
How do I pair my phone with control hub?
Power on your Android Device by holding down the power button. Open the Driver Station application from the HOME Screen. On the Driver Station page, open the menu from the top right corner, then select Settings. Select, Pairing Method.
What is the rev control hub?
The REV Robotics Control Hub is an affordable all-in-one educational robotics controller. It provides students all the necessary interfaces for robotics and mechatronics projects with multiple programming language options.
How do I change my rev expansion hub ID?
Go to advanced settings, then click ‘ change expansion hub address’. Now, change the address to a number that is NOT the address on Hub A.